Missouri requires approved, job-specific training for propane handling and system work under 2 CSR 90-10.012. The Missouri Propane Safety Commission administers this rule.
Match training to the transfer work
Section .012(4) requires initial approved training and examination, followed by training at least every three years. New employees receive employer training until a director-approved program is available. The narrow exception for employees whose only duty is low-emission autogas filling requires manufacturer/installer initial instruction. It is not a general dispenser exemption.[source]
Approved programs cover applicable law and assigned functions, include hands-on training or skills assessment, and require a third-party-graded written examination with a 70% passing score. Program approval lasts two years unless curriculum changes first.[source] Delivery, storage/plant and service duties must match the approved training scope. The current chapter adopts NFPA 58 (2024).[source] This page does not restate that edition’s transfer-attendant or engine-fuel self-service provisions; read the adopted edition and confirm them with the authority having jurisdiction (AHJ).
Make the file easy to use
The cited training provision does not specify an employee-record retention period. Keep course approval, dates, results, skills evidence and job assignments as an office practice. Covered transport duties also carry separate federal hazmat record requirements.
Where do CETP and PEP fit?
The Commission's program criteria expressly identify PERC CETP or equivalent curriculum. This does not automatically approve every PEP course. Confirm the actual course and instructor approval. PERC transition information describes programs, not Missouri approval.
Put the office policy in writing
Use the Policies & Procedures manual to assign training ownership, supervision and record checks. This is an office recommendation; a manual does not replace training, practical skills or required credentials.
Need a trainer? Use Meet Safety Pro.
Sources
- Missouri SOS, 2 CSR 90-10, especially .012(4)-(5) — rechecked 2026-11-08.
- Missouri Propane Safety Commission, Training Program Requirements — rechecked 2026-11-08.
- NFPA 58 (2024), free-access reading page — where to read the edition; its text is not restated here (access checked 2026-11-09).
- 49 CFR §172.704 — rechecked 2026-11-08.
- PERC Education Program — rechecked 2026-11-08.
General information. Confirm current requirements with the responsible agency for your location and job duties.
Use the current training answer above. The retained article below contains earlier guidance and is kept for reference.
Historical article — not current requirements
Propane training and safety rules in Missouri
Missouri training programs must be based on a nationally recognized program (or equal). The Missouri Propane Safety Commission must approve them. The rule changed July 30, 2026. 2 CSR 90-10.012(5).
The current text does not name CETP. It does not auto-approve every PEP course either. Use the Commission's approval process. Current curriculum and approval criteria.
What the rule says
- Everyone who handles LP-gas, or services LP-gas equipment, finishes an initial training program that includes a written exam. 90-10.012(4).
- Training comes again at least every three years. New hires are trained by the employer until an approved program is available. 90-10.012(4)(A).
- An approved program uses a Commission-approved instructor and includes hands-on training or a skills assessment. 90-10.012(5).
- The program's exam needs a passing score of at least 70 percent and is graded by a third party. 90-10.012(5).
- Programs get approved first, then re-reviewed at least every two years or when they change. 90-10.012(5).
- Some workers can skip this. Their only propane job is filling vehicles with autogas, and the system's maker or installer trained them. 90-10.012(4)(B).
What this means for you
When you switch courses, keep the approval letter with the version that was taught. Compare the instructor, the hands-on part and who grades the exam before you move your schedule to a new program.
Need training for your crew?
We don't run classes. Use the trainers on our Recommended Propane Safety Experts page and contact them directly.
Keep the paper trail
An inspector or insurer will ask to see your records. Our Policies & Procedures manual puts your training policy and written procedures in one place. The Propane Safety App/Tank Spotter keeps each employee's training dates and flags renewals. It does not give Commission approval. The Duty to Warn program covers your customer safety notices.
Next step: See the Policies & Procedures manual.
Quick questions
Does a famous national program skip Missouri's approval? No. The rule still requires Commission approval and the listed test conditions. 90-10.012(5).
How often does training repeat? At least every three years. 90-10.012(4).
This is general information, not legal advice. Rules change. Sources reviewed October 2026. Check with the Missouri Propane Safety Commission before you rely on this.
